Declining with Scissors

Tapered Cuts: Scissor over Comb

       It's almost common knowledge the primary conditions in haircutting: dull reduces, adding, clippers reduces, but some of the conditions that are particular to tapering the locks can be stealthily simple-sounding. For instance: the phrase scissor-over-comb indicates just what it says, but it’s not as simple to do until you’ve had some exercise. The objective of this conversation will be to help you comprehend how (and why) to execute a scissor-over-comb cut.

Why scissor-over-comb?

       We all know that adding the locks allows spread the large of the locks (particularly the rougher locks types) and that the bigger greater part of men’s hairstyles are padded reduces that integrate a important level of tapering as the locks goes toward the border of the development place. Well, when the locks is being cut into a very brief design, sometimes trying to increase the locks from the go and keep it in the fingertips isn’t possible.

       Provided, most pointed men’s haircuts are designed using trimmers, but you may not always have accessibility trimmers and seriously, a beautician relaxed with his or her scissers may look for the conversion to trimmers a bit heavy. There’s also the point that even with trimmers, you still need to adhere to up with scissers to combination some place of the cut.

       It’s in these circumstances that scissor-over-comb is most useful. Because you can place the locks comb more carefully to the go and use it to keep the locks in a particular place, you can use the locks comb to alternative for your fingertips and make smaller adding than you could without the strategy. (Using your fingertips to keep the locks boundaries the shortness you can acquire to the width of your fingertips.)

Specific methods for scissor-over-comb

       You can use scissor-over-comb to make consistent adding by basically using the detail of the locks comb as a information or placement the locks comb in a consistent range from the go as you shift along the go. Often, a beautician or barber will use his knuckles as an extra duration information. With exercise, you can handle to make very accurate adding and reduces with this technique.

       The finer-toothed part of the locks comb is used to raise the locks to the preferred level and the scissers are then organised over the locks comb to cut the locks to the preferred duration (typically indicated by the guide).

In some situations, a pointed cut is preferred (where the hair’s levels become smaller as you shift toward the reduced locks lines). The steepness of the tapering is supervised using the knuckles of the side having the locks comb, so that the locks comb is organised in the side, a knuckle of the hand sets against the go and the end of the locks comb perspectives in to the go. This makes an tilted reducing range from the end border range way up, with the quickest measures being at the border hair line. The duration is then supervised by the message of the locks comb as it is organised (whether smooth against the go, on the tooth advantage, or at some place in between).

Cutting and Crosschecking

       Once you’re relaxed with placement the locks comb, you can begin exercising your reducing. It is suggested that you do this on an old manikin that has been cut too brief for other conventional reducing methods. You can set information measures by aiming the locks comb top to base along the go at the place you wish to set your tapering measures and creating information reduces on either part of the area you are reducing.

       Once this is done, you can begin reducing your levels using scissor-over-comb and basically adhere to your information measures for combination verifying reasons. A used beautician can cut almost any cut using scissor-over-comb, though some reduces perform better conducted using different methods. However, when it comes to developing brief, pointed reduces without using trimmers, scissor-over-comb is definitely the way to go.